Baxi Solo 2 PF Quick Start Manual download pdf (Page 34)

8.0 Overheat Cut-off Device

8.1 Operation

1. The overheat cut-off device is of the manual

reset type and therefore it is important that the

user knows how to reset the control should it

ever cut out.

NOTE: Cut-out is indicated by illumination of

the neon light on the control box.

2. Remove the lower door panel by following the

sequence of diagrams (Fig 87).

3. To reset the boiler - Turn the boiler

thermostat control knob fully anti-clockwise to the

OFF position marked ‘0’ (Fig. 88). Wait ten

seconds, turn the control knob clockwise to the

required thermostat setting, the red neon goes

out, the boiler will start automatically.

4. No adjustment to the gas controls or main

thermostat are required.

5. If the overheat thermostat drops out

repeatedly, refer to the fault finding chart at the

rear of this booklet or consult a competent

service engineer.

Overheat

Boiler On

Fan On

Pilot On

Burner On

Overheat Neon

Warning

Fig. 87

Fig. 88

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

No comments

Baxi Solo 2 PF Quick Start Manual Page 34