Baxi Solo 2 PF Quick Start Manual download pdf (Page 18)

5.0 Installation

5.7

Fitting the Back Plate

1. Engage the assembly into the hole previously

cut in the wall and slide in place (Fig. 31).

2. Secure the assembly to the wall at the

previously drilled anchorage points with suitable

screws (Fig. 31). Before finally tightening the

screws, check that the assembly is level.

3. Make good between the wall and the air duct

outside the building if the internal fitting kit has

not been used (Fig. 32).

4. The flue trim provided may be fitted if required,

to neaten up the make-up around the terminal.

This plate may also be used as a protection plate

on outside walls of combustible material.

5. Fit the trim over the flue terminal and mark

through the four securing holes. Remove the trim,

drill holes 63mm (2

in) deep to accept suitable

wall plugs. Fit the trim over the flue terminal and

secure using suitable screws (Fig. 33).

Fig. 31

Fig. 32

Fig. 33

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

No comments

Baxi Solo 2 PF Quick Start Manual Page 18