Baxi Solo 2 PF Quick Start Manual download pdf (Page 37)

10.0Changing Components

Centre

Retaining

Rivet

Fig. 98

Fig. 99

Fig. 100

Fig. 101

Fig. 102

Fig. 103

10.1 Changing Components

1. When changing components ensure that the

gas and electrical supplies are isolated before the

work is started.

2. Before changing any components please read

Section 1.3 Important Information.

3. Remove the outer case lower door panel

(Fig. 98).

4. Remove the outer case from the boiler by

unscrewing the two screws and lift the case clear

(Fig 99).

10.2 Replacing the Circuit Board

1. Ensure that the electrical supply is isolated.

2. Remove the cover from the front of the controls

box (Fig. 100).

3. Release the mains cables from the cable

clamps and unplug the mains connection blocks

from the circuit board (Fig. 101).

4. Remove the screw retaining the thermostat

control panel and slide the circuit board from the

box.

5. Carefully withdraw the centre pin from the

retaining rivet which then allows the retaining rivet

to be removed. Remove the thermostat control

panel (Fig. 102). (On reassembling ensure the

control panel is located over the retaining rivet

body before inserting the centre pin.)

6. Disconnect the plugs from the sockets on the

circuit board (Fig. 103).

7. Replace new circuit board in reverse order

checking that the connections are correct as

shown in the diagram (See Electrical Connections

section 5.17 of these instructions) and that the

harness is retained in the strain reliefs.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Baxi Solo 2 PF Quick Start Manual Page 37

Comments to this Manuals

Related products and manuals for Fireplaces Baxi Solo 2 PF