Baxi Solo 2 PF Quick Start Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
6.0 Commissioning the Appliance
31
6.1 Commissioning the Appliance
1. Flush the whole system in accordance with BS
5793:1992 (see Section 3.1 Water Circulating
Systems). Check for water leaks.
2. Purge away air from the supply pipe at the gas
service cock. (BS 6891: 1988) (Fig. 79).
3. Ensure that the electrical supply is isolated.
4. Check the electrical supply for earth continuity,
polarity, short circuit and resistance to earth.
5. Turn the gas service cock anti-clockwise to the
ON position and check for gas soundness up to
the gas valve.
6. Loosen the pressure test point screw on the
right hand side of the gas control valve (there is
no need to completely remove this screw to
obtain a pressure reading) and connect a
pressure gauge.
7. Turn the boiler thermostat control knob fully
anti-clockwise to the OFF position marked 0
(Fig. 80).
8. Ensure that the electricity supply is turned ON
and set any external controls to the ON position.
9. Turn the boiler thermostat knob fully clockwise.
10. The fan will start running and after
approximately 5 seconds, the ignition spark will
commence. (NOTE: This may increase up to 1
minute in extremely cold weather).
11. The sparking will continue until the pilot light
is established (Fig. 81) and then the main burner
will light from the pilot flame.
12. Check that both the main burner and the pilot
are alight by observing through the viewing
window. The indicator lights should also be
illuminated.
13. Should this sequence not occur, then refer to
the fault finding section of these instructions.
NOTE: The pilot rate for this appliance is
factory set, sealed and therefore non-
adjustable.
0
6
5
4
3
2
1
*
Overheat
Boiler On
Fan On
Pilot On
Burner On
Overheat Neon
Warning
17 3
Fig. 79
Fig. 80
Fig. 81
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Comments to this Manuals

No comments