Baxi Solo 2 PF Quick Start Manual download pdf (Page 12)

4.0 Site Requirements

12

4.5

Ventilation of Compartments

1. Where the appliance is installed in a cupboard

or compartment, no air vents are required.

NOTE: The ventilation label on the front of the

outer case MUST NOT BE REMOVED when

the appliance is installed in a compartment or

cupboard.

2. B.S. 5440 Part 2 Clause 4.2 refers to room

sealed appliances installed in compartments.

The Solo 2 PF will run sufficiently cool without

ventilation.

4.6 Gas Supply (Fig. 13)

1. The gas installation should be in accordance

with BS 6891.

2. The connection of the appliance is a RC

1

/

2

(

1

/

2

in BSPT internal) located at the rear of the gas

cock.

3. Ensure that the pipework from the meter to the

appliance is of adequate size. Do not use pipes

of a smaller diameter than the appliance gas

connection.

4.7 Electrical Supply

External wiring must be correctly earthed,

polarized and in accordance with CURRENT

I.E.E. WIRING REGULATIONS.

The mains supply is 230V ~ 50Hz fused at 5A.

NOTE: The method of connection to the

electricity supply must facilitate complete

electrical isolation of the appliance.

Connection may be made via a fused double-

pole isolator with a contact separation of a least

3mm in all poles and serving the appliance and

system controls only.

Fig. 13

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comments to this Manuals

No comments