Baxi Eco 3 Service Manual download pdf (Page 12)

7.0 Site Requirements

7.1 Information

1. The installation must be carried out by a CORGI

Registered Installer or other registered competent

person and be in accordance with the relevant

requirements of the current G

AS SAFETY (Installation

and Use) R

EGULATIONS, the BUILDING REGULATIONS

(Scotland)(Consolidation), the LOCAL BUILDING

REGULATIONS, the current I.E.E. WIRING REGULATIONS

and the bye laws of the LOCAL WATER UNDERTAKING.

Where no specific instruction is given reference

should be made to the relevant BRITISH

STANDARD CODES OF PRACTICE. For Ireland

install in accordance with IS 813 “I

NSTALLATION OF

GAS APPLIANCES”.

7.2 B.S. Codes of Practice

Standard Scope

BS 6891 Gas Installation.

BS 5546 Installation of hot water supplies for

domestic purposes.

BS 5449 Part 1 Forced circulation hot water systems.

BS 6798 Installation of gas fired hot water boilers.

BS 5440 Part 1 Flues.

BS 5440 Part 2 Ventilation.

BS 7074 Expansion vessels and ancillary

equipment for sealed water systems.

BS 7593 Treatment of water in domestic hot water

central heating systems.

WARNING - The addition of anything that may

interfere with the normal operation of the

appliance without the express written permission

of Baxi UK Limited could invalidate the appliance

warranty and infringe the G

AS SAFETY

(Installation and Use) REGULATIONS.

7.3 Clearances (Fig. 12 & 13)

1. A flat vertical area is required for the installation

of the boiler.

2. These dimensions include the necessary

clearances around the boiler for case removal,

spanner access and air movement. Additional

clearances may be required for the passage of

pipes around local obstructions such as joists

running parallel to the front face of the boiler.

7.4 Location

1. The boiler may be fitted to any suitable wall with

the flue passing through an outside wall or roof and

discharging to atmosphere in a position permitting

satisfactory removal of combustion products and

providing an adequate air supply. The boiler should

be fitted within the building unless otherwise

protected by a suitable enclosure i.e. garage or

outhouse. (The boiler may be fitted inside a

cupboard - see Section 7.5).

2. If the boiler is sited in an unheated enclosure then

it is recommended to leave the ON/OFF/RESET

Selector Switch in the domestic hot water and

central heating position to give frost protection.

3. If the boiler is fitted in a room containing a bath or

shower reference must be made to the current

I.E.E. W

IRING REGULATIONS and BUILDING

REGULATIONS. If the boiler is to be fitted into a

building of timber frame construction then reference

must be made to the current edition of Institute of

Gas Engineers Publication IGE/UP/7 (Gas

Installations in Timber Framed Housing).

200mm Min

780mm

450mm

200mm Min

5mm Min

5 mm Min

450mm Min

For Servicing

Purposes

Fig. 12

Fig. 13

In Operation

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comments to this Manuals

No comments

Baxi Eco 3 Service Manual Page 12

Comments to this Manuals

Related products and manuals for Water heaters & boilers Baxi Eco 3