Baxi EcoBlue Plus Combi Quick Start Manual Page 35

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 34
7212136 - 02 (08/14) EcoBlue Plus Combi 35
Before Installation 5
5.3.9 Flue/Chimney Lengths
1. The standard horizontal telescopic flue kit allows for lengths
between 315mm and 500mm from elbow to terminal without the
need for cutting (Fig. 11). Extensions of 250mm, 500mm & 1m
are available.
The maximum permissible equivalent flue length is:
10 metres (60/100 system - vertical & horizontal)
20 metres (80/125 system - vertical & horizontal)
15 metres (80/80 twin pipe)
8 metres (60/100 system - vertical connected to ridge
terminal)
5.3.10 Flue/Chimney Trim
1. The flexible flue trims supplied can be fitted on the outer and
inner faces of the wall of installation.
5.3.11 Terminal Guard
1. When codes of practice dictate the use of terminal guards
(Fig. 12) ‘Multifit’ accessory part no. 720627901 can be used
(NOTE: This is not compatible with Flue Deflector referred to
below).
2. There must be a clearance of at least 50mm between any
part of the terminal and the guard.
3. When ordering a terminal guard, quote the appliance name
and model number.
4. The flue terminal guard should be positioned centrally over
the terminal and fixed as illustrated.
5.3.12 Flue/Chimney Deflector
1. Push the flue deflector over the terminal end. It may point
upwards as shown, or up to 45° either way from vertical. Secure
the deflector to the terminal with screws provided (Fig. 13).
5.3.13 Flue/Chimney Accessories
For full details of Flue Accessories (elbows, extensions,
clamps etc.) refer to the Flue Installation Guide supplied in the
literature pack.
315mm
500mm
Flue Deflector
Fig. 11
Fig. 12
Fig. 13
© Baxi Heating UK Ltd 2011
GUIDA NCE NOTES
Flue Accessories & Fitting Guide
Ø 60/100 Flue Systems
Ø 80/125 Flue Systems
Ø 80/80 Twin Flue Systems
Plume Displacement Kit
(Ø 60/100 Flue Systems)
READ THESE INSTRUCTIONS IN CONJUNCTION WITH THE BOILER
INSTALLATION INSTRUCTIONS BEFORE FITTING THE FLUE
Please leave these instructions with the
Installation & Servicing Instructions.
IMPORTANT NOTE: This document
will assist in the correct installation of
the various flue & chimney systems
described within. However, it is the
responsibility of the installer/Gas Safe
registered commissioning engineer to
ensure that the flue & chimney system
is fitted safely and in compliance with
the relevant standards and practices in
force in the country of installation.
5.4 Transport
1. This product should be lifted and handled by two people.
When lifting always keep your back straight and wear protective
equipment where necessary. Carrying and lifting equipment
should be used as required. e.g. when install in a loft.
Ensure that no part of
the white outer chimney
duct is visible
Page view 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 75 76

Comments to this Manuals

No comments