Baxi MainEco Heat 15 Service Manual download pdf (Page 41)

7215845 - 01 (08/14) MainEco Heat 41

Commissioning 7

7.4 Gas Settings

7.4.1 ‘Chimney Sweep’ Mode (CSM)

1. The current operating condition of the boiler is shown by the

button on the User Interaction Controller. The

button can flash in a range of colours and at different

frequencies.

2. Follow the flow chart on the next page to comply with the

requirement to check combustion on commissioning.

3. Setting the boiler to maximum and minimum heat outputs is

achieved as follows;

• Press the button for 3 seconds.

• CSM is activated and will go to the min rate.

• Pressing again will make it adjust to max rate.

• To exit press the RESET for 3 seconds.

Plug

Analyser Probe

Flue Sampling

Point

After refitting the sampling point

plug ensure there is no leakage

of products !

Fig. 33

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

No comments

Baxi MainEco Heat 15 Service Manual Page 41