Baxi EcoBlue Advance Combi Quick Start Manual download pdf (Page 48)

48 EcoBlue Advance Combi Comp No. 7212138 - 02 (06/14)

8 Operation

8.1 General

1. It is the responsibility of the installer to instruct the user in the

day to day operation of the boiler and controls and to hand over

the completed Benchmark Checklist at the back of this manual.

2. Set the central heating and hot water temperatures to the

requirements of the user. Instruct the user in the operation of the

boiler and system.

3. The temperature on the boiler must be set to a higher

temperature than the cylinder thermostat to achieve the required

hot water demand.

4. Instruct the user in the operation of the boiler and system

controls.

5. Demonstrate to the user the action required if a gas leak

occurs or is suspected. Show them how to turn off the gas

supply at the meter control, and advise them not to operate

electric light or power switched, and to ventilate the property.

6. Show the user the location of the system control isolation

switch, and demonstrate its operation.

7. Advise the user that they may observe a plume of vapour from

the flue terminal, and that it is part of the normal operation of the

boiler.

8. The method of repressurising the primary system should be

demonstrated.

9. If at any time after installation it is necessary to drain & refill

the central heating system (e.g. when replacing a radiator) the

De-Aeration Function should be activated (see 7.6.2).

8.2 To Start-up

Switch on the boiler at the fused spur unit and ensure that the

time control is in the on position and any other controls (e.g.

room thermostat) are calling for heat.

Press the once to bring the boiler out of Standby mode.

The boiler will begin its start sequence.

8.3 To Shutdown

Isolate the mains power supply at the fused spur unit.

Isolate the gas supply at the boiler valve.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 75 76

No comments

Baxi EcoBlue Advance Combi Quick Start Manual Page 48